These four steps will compile, test and install LyX:
- 0) Linux users beware: if compiling the Qt frontend, you need
- qt4 and qt4-devel packages of the same version to compile LyX.
+ 0) Linux users beware: You need qt4 and qt4-devel packages
+ of the same version to compile LyX.
1) ./configure
configures LyX according to your system.
- When compiling for Qt, you may have to set
- --with-qt4-dir=<path-to-your-qt4-installation>
- if the environment variable QTDIR is not set.
+ You may have to set
+ --with-qt4-dir=<path-to-your-qt4-installation>
+ if the environment variable QTDIR is not set (for example,
+ '--with-qt4-dir=/usr/share/qt4/'). Alternatively, you could
+ install pkgconfig (the name might vary depending on your
+ distribution).
See Note below if ./configure script is not present.
2) make
-----------------------------
If you have checked this out from Subversion, you need to have:
-* automake >= 1.5
+* automake >= 1.8
* autoconf >= 2.59c
* gettext >= 0.12
Then type "./autogen.sh" to build the needed configuration
You will also probably need GNU m4 (perhaps installed as gm4).
+
Requirements
------------
This means that gcc users will have to install the relevant libstdc++
library to be able to compile this version of LyX.
-LyX has been tested with Qt 4.4.x and 4.5.x. For compilation you
-need to compile against at least Qt 4.4.2. The only special point to make
-is that you must ensure that both LyX and the Qt libraries are compiled
-with the same C++ compiler.
+LyX has been tested with all Qt versions since Qt 4.2.2. For compilation
+you need to compile against at least Qt 4.2.2. The only special point to
+make is that you must ensure that both LyX and the Qt libraries are
+compiled with the same C++ compiler.
Note that if Qt is using Xft2/fontconfig, you may need to install the
latex-xft-fonts package (at ftp://ftp.lyx.org/pub/lyx/contrib/) to get